TE200A Power Controller
Description
TE200A Two leg, three phase, burst firing Power Controller
Ergonomic design
Analog input configured as voltage, current or potentiometer
Burst firing or single cycle firing modes
Input current 4-20mA
Input voltage 0-5Vdc, 0-10Vdc
Nominal current per phase 16-63A at 45°C
The TE200 range is designed for general purpose three phase applications which use three wire resistive or short wave infrared (SWIR) loads. Two of the three phases are switched by the TE200, the third phase being directly connected.
Specification
| Digital Comms | None |
|---|---|
| Maximum Current (Amps) | 63A |
| Maximum Voltage (Volts) | 500V |
| Controlled Phases | 2 |
| PLF and/or PLU | No |
| Current Limit | No |
| Diagnostics | No |
| Alarm Types | Nej |
| Input Analogue | Yes |
| Input Logic | Yes |
| Firing Mode Burst Firing | Yes |
| Firing Mode Phase Angle | No |
| Heater Type Constant Resistance | Yes |
| Heater Type SWIR | Yes |
| Heater Type Variable Resistance | No |
| Heater Type Inductive/Transformer Coupled | No |
